If you have iMovie, you might also have iDVD. What (free) program would use for converting the file ? (or dvd burn program that compresses the project for burn ?) 19 MbPS, and the bitrate bounces up and down). 5MbPS to be safe remember, your audio will be about. If your result is between 2 and 9 megabits per second, it'll fit, and then use that number for encoding your video (I'd round down by about. So for a 95 minute project you'd enter 4.25GiB/95 minutes. Just go there and divide 4.25GiB (the size of a single layer DVD, rounded down to figure for overhead) over the number of minutes your video is. You can figure this out by using Wolfram|Alpha.
Therefore to figure out if it's possible to fit your video on to a DVD, the length is more important. A file size that large could realistically be DV at 25 or 50 MbPS or ProRes 422 with a bitrate as high as 220 MbPS.ĭVD Video specification has a bitrate no lower than 2MbPS, and no higher than 9MbPS (including audio). Your file could reasonably be compressed using any number of codecs at almost any possible bitrate. What is the best approach for taking a large imovie file (.mov, 25gb) and burning it to DVD. Go to this topic to learn how: Edit or revert cropping, rotating, or the Ken Burns effect.OK, this is DVD Burning 101, people, so strap in, pay attention, take notes, and I'll field questions once I'm done here. You can change or remove the Ken Burns effect at any time. Ken Burns: Randomly assigns a motion effect to the photo, so that it appears as if the camera is panning and zooming across the photo. To apply the settings to photos as they’re added to your project, select “Applies when added to project.” No photos already in the project are affected.Ĭhoose one of the following from the Initial Photo Placement pop-up menu:įit in Frame: Adjusts the photo size to fully fit within the aspect ratio you’ve set for the project.Ĭrop: Fills the frame with as much of the photo as possible, though the entire photo may not fit within the aspect ratio you’ve set for the project. To apply the settings to all photos already in your project and to all images you add later, select “Applies to all photos.” The File menu appears in a light gray bar across the top of your computer screen.ĭrag the Photo Duration slider to set how many seconds you want each photo to remain onscreen in your project. Select a project in the Project Library, or open a project, and then choose File > Project Properties. As you add photos, these standard settings are applied automatically.
You can adjust the default settings for the crop, duration, and the Ken Burns effect applied to photos you add to your project.
0 kommentar(er)
